Lead time: 1 week

Monitors Lithium battery packs and performs cell-balancing.

Open Firmware

Install in a matter of minutes with the optional install kit (coming soon. Email us for any questions)

Connects to JST XHP female balance leads on battery pack

Communication Protocol:

• SMBUS: I2C based 2-wire protocol supported in firmware. Communicates to Pixhawk, Ardupilot, ROS
• CAN-FD: 2-wire high speed CANBUS interface
• LIN: 1-wire robust automotive communication protocol

Supported burst current (5 sec):

• 150A
• 210A with optional heatsink

PCB Size: 86x44mm

Connector lead:

• Negative/Positive terminal: 8in (203mm)
• Connector: XT90I-F AMASS
• Wire gauge: 10AWG (Optional 8AWG). Make sure the gauge of battery and BatMon are the same. This makes it easier to crimp them together.

Optional features:

• OLED Display and buzzer: Show battery related information for easy reading. Buzzer can be programmed for low voltage, high current or other warning indications
• External Thermistor: Attach to specific areas of the battery to the monitor the temperature. This board supports 2 thermistors.